MT6572__welcome__V2__V2__4.4.2__ALPS.KK1.MP7.V1.7

Android Infor
 Brand : welcome
ProdName : V2
ProdModel : V2
 Device : V2 AndroidVer: 4.4.2 MTKxCPU : MT6572 MTKxPRJ : ALPS.KK1.MP7.V1.7 [Read Ok] : preloader_xiaoxin.bin [Read Ok] : MBR [Read Ok] : EBR1 [Read Ok] : lk.bin [Read Ok] : boot.img [Read Ok] : recovery.img [Read Ok] : secro.img [Read Ok] : logo.bin [Read Ok] : system.img [Make Ok] : cache.img [Make Ok] : userdata.img [ScatCFG] : MT6572 / V1.1.1 / xiaoxin / EMMC Android Info saved HWConfig Info saved FW Size : 738 MiB Scatter saved to : E:\clone huawei v2\MT6572__welcome__V2__V2__4.4.2__ALPS.KK1.MP7.V1.7\ All done!

Contact-US

Flash Tool - Download

What You Need To Use Sp Flash Tool

• Since Sp Flash Tool is a PC based utility software you need a Windows
  Or a Linux computer (32 or 64-bit)
• Original USB cable of your device
• MediaTek USB-VCOM drivers Firmware file you are going to flash along
  with the scatter file
  Scatter file contains the information of device structure and the memory map of the image file. Since sp flash tool is scatter based always check if the firmware file contains the scatter file.

How To Flash Stock ROM Using Sp Flash Tool

• Download Sp Flash Tool and extract it
• Download Stock Firmware you wish to flash and extract it
• Switch off your smart device
• Now click "Flash_exe" to launch the Sp Flash Tool
• Click download tab and click the scatter loading button to load
  scatter file
• Scatter file is located in the firmware file
• Click on the "download icon" to launch the flashing process
• Then connect your smart device and click volume up or down button to
  ease the computer to recognize the smart device
• Wait for about 10 minutes, after a successful operation a message
  will be displayed along with a green circle.

How To Flash Custom ROM Using Sp Flash Tool

• Download the relevant Custom ROM for you android MediaTek device
• Unzip the folder
• Start your computer in “Device driver signature disabled” mode
• Install MediaTek USB-VCOM drivers
• Launch Sp Flash Tool in “Administrator Mode”
• Next, click “Scatter-loading” and load the scatter file that is
  located in the firmware file
• Now select the “Download Agent” go to the Sp Flash Tool folder and
  select “MTK_AllInOne_DA.bin”
• After the above steps go to the”Format” tab and check the validation
• Now switch off your device and connect
• Then click start and to format the device
• Next, disconnect the device and click on the download button under
  the download tab
• Again connect the device
• Then the custom ROM installation will begin and wait for about 10
  minutes A green tick will appear after successful installation

Hope this guide would be helpful to you.